Standard-Duty Underpinning Brackets for Helical Pile Foundation System For use with 1 1/2″ and 1 3/4″ square shaft anchors, as specified below, each bracket is identified by the size stamped on the vertical gusset. Brackets also may be used in conjunction with Uplift-Restraint Bracket. Bracket comes complete with the hardware required for assembly of bracket; does not include concrete anchor bolts.
The lifting assembly, consisting of the underpinning bracket and jacking tool, is designed to lift with hydraulic jack assist as shown below. However, if jack assist is not available, lifting can be done with the bolts of the bracket. The recommended method is to use a hydraulic jack with a load gauge to avoid exceeding the ratings of the brackets.
Read the article here
Source: http://www.abchance.com/
Timber brackets by Hubbell are perfect for connecting timber beams to helical piles. These bracke...
Save time and money with the CHANCE® Interior Slab Bracket from Hubbell Power Systems, Inc. The mult...
Hubbell Power Systems, Inc. has recently launched the CHANCE interior Slab Bracket (ISB) used for re...
Meet the Atlas Resistance by Hubbell. Continuous Lift Pier Systems by Hubbell are used for lifts...
Concrete brackets from CHANCE, Hubbell are used for channel slab pile cap assemblies The as...
Meet Hubbell's Plate Pier Systems for easy surface mount installation. The Atlas Resistance...
Hubbell Power Systems, Inc. has launched this assembly in order to raise the concrete slab edge or n...
A helical anchor/pile is an extendable deep foundation system with helical bearing plates welded to...
Check the shear connection for the IPE450-S275 for the design shear VEd=500KN. Bolts M20-8.8, plate...