A collection of publications available on the internet at no cost. (Currently 1,418 different resources in 20 sections).

New Additions:

Bridges

Dietz, J., (2003). Dynamic Measurements of a Prestressed High Performance Concrete Bridge. LACER, No. 8, pp. 113-119.

Fujikura, S., Bruneau M., Lopez-Garcia, D., (2008). Experimental Investigation of Multihazard Resistant Bridge Piers having Concrete-Filled Steel Tube under Blast Loading. Journal of Bridge Engineering, Vol.13, No.6, pp. 586-594. ASCE.

Zderic, Z., Runjic, A., Hrelja, G., (2007). Design and Construction of Cetina River Arch Bridge. ARCH'07, 5th International Conference on Arch Bridges, Multicomp, Lda Publishers, Madeira, pp. 745-750.

Petrangeli, M.P., (2007). Prefabrication of Medium Span Arch Bridges. ARCH'07, 5th International Conference on Arch Bridges, Multicomp, Lda Publishers, Madeira, pp. 759-766.

Repair and Retrofit of Structures

Concrete Structures

Khalil, H.S.E., (1989). Performance of Epoxy-injected concrete in hot weather conditions. MSc. Thesis, King Fahad University of Petroleum and Minerals, Dhahran, Saudi Arabia.

Kara, M.E., (2006). Behavior of Reinforced Concrete Frames with Reinforced Concrete Partial Infills. ACI Structural Journal.

Concrete Structures

Mertol, H.C., (2008). Characteristics of Compressive Stress Distribution in High-Strength Concrete. ACI Structural Journal.

Collins, M.P., (2008). Where is Shear Reinforcement Required? Review of Research Results and Design Procedures. ACI Structural Journal.

Tureyen, A.K., (2006). Shear Strength of Reinforced Concrete T-Beams without Transverse Reinforcement. ACI Structural Journal.

Rahal, K.N., (2006). Evaluation of AASHTO-LRFD General Procedure for Torsion and Combined Loading. ACI Structural Journal.

Standards and design codes

Concrete Masonry Manual, 8th Edition: Incorporating Masonry Requirements in the Application of the National Building Regulations, (2007). Edited by Lane, J.W. Published by Concrete Manufacturers Association.

Masonry Structures

Detailing of Concrete Masonry, Vol.1 - Solid Units 140 mm: Concrete Masonry - Strong, Durable, and Attractive, (2008). 4th Edition. Published by Concrete Manufacturers Association. Edited by Lane, J.W., Kelly, P.J., Catsavis, J.H.

Detailing of Concrete Masonry, Vol.2 - Hollow Units 140/190: Concrete Masonry - Strong, Durable, and Attractive, (2004). 4th Edition - Revised. Published by Concrete Manufacturers Association. Edited by Lane, J.W., Cairns. J.E., Catsavis, J.H.

Detailing of Concrete Masonry, Vol.3 - Cavity Walls 240 to 290: Concrete Masonry - Strong, Durable, and Attractive, (2005). 3rd Edition - Revised. Published by Concrete Manufacturers Association. Edited by Lane, J.W., Cairns. J.E.

Gregorczyk, P., Lourenco, P.B., (2000). A review on Flat-Jack Testing. Universidade do Minho, Departamento de Engenharia Civil, Guimaraes, Portugal. No.9, pp. 39-50.